13
Setting the amount of rinse aid used
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
1
Press the
[On/Off]
button.
2 Hold down the “
A
” button (see page 17) and press
[Start]
until the
display indicates “
d:00
”. Release both buttons.
3 Press the “
A
” button until the display shows “
r:05
”.
4 Press the “
C
” button to select the desired setting.
“
r:00
” = dispenser is OFF
“
r:01
” = lowest setting
“
r:02
” = low setting
“
r:03
” = medium setting
5 Press
[Start]
to save the setting.
Note: Using rinse aid and setting the dispenser to “r:00” may result in longer
cycle times.
Salt
Your dishwasher requires soft water to ensure proper washing results
and is equipped with an internal water softening system. However, if you
have a household water softening system, the internal system provided
is not needed.
For the water softening system to function properly, it will need to use the
dishwasher water softening salt. The amount of salt dispensed can be set
from “H:00” to “H:07”. Salt is not required at H:00 (this is the default factory
setting). The amount of salt required depends on the degree of hardness of
your tap water. See
Hard Water and your Dishwasher Table
on next page.
To use the provided water hardness test strip see below.
1
Hold down the
“A”
button (see page 17) and press
[START]
until
the display indicates
“d:00”
.
2 Release both buttons. Press the
“C”
button to select the desired
setting.
3
Save the selected setting by pressing
[START]
.
“
r:04
” = medium/high setting
“
r:05
” = high setting
“
r:06
” = highest setting
