English 5
Installation
Installing the Appliance
CAUTION!
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
1. Remove and discard packing materials.
2. Remove all items from the oven to assure oven door
does not get damaged.
3. Verify that the cabinet opening is flat and level.
4. Carefully place the oven in the opening. Resting the
oven on the cabinet base support. Slide the unit into
the opening until it is approximately 6" (152 mm) from
being fully installed.
90°
5. As the oven is slid into position, guide the pigtail
through the opening of the adjacent cabinet or base
support. Verify the pigtail is not trapped between the
oven and cabinet wall.
6. Position the steam oven fully in the cabinet opening.
7. Gently open and close the oven door to check
operation and to verify that there is no interference.
Securing to the Cabinet
8. Open the oven door and locate the two mounting holes
on each side of the oven.
9. Use a 1/16” (1.588 mm) drill bit to drill pilot holes into
the cabinet.
10. Using the mounting screws provided, secure the oven
to the cabinet.
CAUTION!
Failure to install the mounting screws may cause the
oven to tip forward during use.
