Conettix Universal Dual Path Communicator
Configuration and Diagnostics | en
53
Bosch Security Systems, Inc.
Installation and Operation Manual
2017.11 | 05 | F.01U.311.207
*
1.
Diagnostic
1
Select this option to run various diagnostic procedures.
Available options include:
–
Modify Diagnostic Settings. Use this option to determine
which type of messages display during diagnostics. This
option is for use only under Bosch direction. A sub-menu
of options includes:
–
Receiver Communications Verbose Mode
–
Cellular Modem Verbose Mode
–
Network Communications Verbose Mode
–
Network Operations Verbose Mode
–
Input Power & Battery Verbose Mode
–
Module Operations Verbose Mode
–
All Verbose Modes Off
–
Re-print Saved Console Message. Use this option to print
any diagnostic messages that have already occurred and
are stored in the B465’s buffer. This can print what just
happened if an issue occurs.
–
Enable Live Console Messages. Use this option to provide
real time output of diagnostic messages. This allows the
computer running TeraTerm to log what is occurring in
the module and can log for longer periods of time.
–
LED/Sounder Test. Use this option to test the operation
of the piezo sounder.
–
Communicator Test Menu. Use this option to test
communication paths between the B465 and the
connected receivers.
2. Change
Passcode
2
Select this option to change the passcode used to enter in the
USB menu. Enter a new passcode twice to change it. The
second entry confirms the new passcode. Passcodes must be
4-10 characters long, and are case-sensitive. 0-9, A-Z, a-z, and
special characters are allowed.
3. Reset to
Factory
Defaults
3
Select this option to reset all factory default values. All fields
are cleared and the factory default values are restored.
4. Clear/
Reset Status
4
Select this option to reset the B465 status.
5. Firmware
Update
5
Select this option to update the B465 firmware.
For firmware update instructions, refer to
*
The Diagnostic parameter is used in troubleshooting communication issues with the B465.
Use of the Diagnostic parameter is to be used only at the direction of TECHNICAL
SUPPORT.
6.4
Firmware Update
You can update the B465 firmware through the USB interface and a communication program
such as Tera Term, or with RPS. For Tera Term installation instructions, refer to
Summary of Contents for B465
Page 1: ...Conettix Universal Dual Path Communicator B465 en Installation and Operation Manual ...
Page 2: ......
Page 114: ......