![background image](http://html.mh-extra.com/html/bosch/b465/b465_installation-and-operation-manual_38832033.webp)
Conettix Universal Dual Path Communicator
IP Communicators | en
33
Bosch Security Systems, Inc.
Installation and Operation Manual
2017.11 | 05 | F.01U.311.207
5
IP Communicators
The module uses the on-board Ethernet connector, and/or optional cellular communicators to
communicate with a Conettix D6600, Conettix D6100i or a Conettix D6100IPv6
Communications Receiver/Gateway. Please refer to the Specifications section for supported
cellular communicator modules. Using Conettix IP communication protocol offers a secure
path that includes anti-replay/anti-substitution features and provides enhanced security with
up to AES 256-bit encryption.
The module supports Domain Name System (DNS) for central station communication. DNS
provides ease of use, eliminating the need to use static IP addresses as your reporting
destination, and accommodates a simple solution for central station disaster recovery.
5.1
Onboard Ethernet
The built-in Ethernet port on the control panel allows for a network connection without the
need for additional modules. The port supports both 10 Base-T (10 Mb) and 100 Base-TX (100
Mb) standards. The port supports full duplex, half duplex, and HP AUTO_MDIX communication,
using a standard Ethernet cable.
Supervision
The B465 supervises its on-board Ethernet communicator when it is configured as either the
preferred network technology or the alternate network technology. Supervision ensures
reliable end to end network communications. If the on-board Ethernet communicator does not
receive a response to supervision polls, the B465 creates a communication trouble event. The
trouble shows on the trouble LED. You can configure the B465 to send a trouble report to a
second receiver, or over an optional cellular network.
On-board Ethernet diagnostics LEDs
The B465 includes the following on-board LEDs to assist with troubleshooting the onboard
Ethernet connection.
1
2
ETHERNET
MODULE 1
MODULE
RELEASE
USB
ETHERNET
100BASE-T
LINK
E 1
Figure
5.1: On-board Ethernet connector and LEDs
Callout
ー
Description
1
ー
100BASE-T LED (green)
2
ー
LINK LED (yellow)
Refer to
B465 LED status indicators, page 80
for information on the 100BASE-T and LINK
LEDs.
5.2
Connettix Plug-in Cellular Communicator
Cellular plug-in communicators provide communication between the control panel and central
monitoring stations using a cellular network. The B465 supports one plug-in cellular module.
Supervision
The B465 supervises the plug-in cellular communicator when it is configured as either the
preferred network technology or the alternate network technology. Supervision ensures
reliable end to end network communications. If the plug-in cellular communicator does not
Summary of Contents for B465
Page 1: ...Conettix Universal Dual Path Communicator B465 en Installation and Operation Manual ...
Page 2: ......
Page 114: ......