EURO • BA F016 L69 923 • AXT RAPID 180/200 • GB • OSW 03.06
English - 3
Remove the machine from the package.
Mount the wheels and the undercarriage.
The blade continues to rotate for a few
seconds after the machine is switched off.
Allow the motor/blade to stop rotating be-
fore switching “on” again.
Do not rapidly switch off and on.
Starting:
Rotate the On/Off switch
2
to position “
II
”, allow the
machine to start and release the switch. It will now
move to position “
I
”.
Note:
The machine will not start unless the securing
knob
3
is fully tightened.
Stopping:
Rotate the On/Off switch
2
to position “
0
”.
Note:
The blade will stop automatically before the
cover
11
can be removed.
Emergency Stop:
Press the On/Off switch
2
.
Restart Protection
After a mains failure, or if the product cuts out due to
overloads, the machine cannot restart on its own
when the power returns or when protector resets.
To restart the machine:
Set the On/Off switch
2
to “
0
”.
Rotate the On/Off switch
2
to position “
II
”, al-
low the machine to start and release the
switch. It will now move to position “
I
”.
Overload Protection
Overloading (e. g. blocking up of the cutter) can lead
to a standstill of the machine after a few seconds. Af-
ter a short period, the machine can be switched on
again. If the machine blocks again turn it off.
Remove blockage (see “Removing blockage”), and
restart.
In order to collect the chopped material, fasten the
carrying straps of the collecting bag
7
(accessory) to
the two hooks
9
while the shredder is switched off.
Feed the material to be chopped through the feed in-
take.
Longer material standing out from the ma-
chine could lash out when being cut!
Please keep a safe distance!
Only insert as much material so that the feed in-
take
1
will not be blocked up.
Do not fill soft waste such as kitchen rubbish into the
shredder but compost directly.
Take care that the chopped material can fall freely
from the discharge chute
8
– danger of backing up!
The ventilation slots
5
must not be covered by the
collecting bag or the chopped material.
Avoid blocking the discharge chute
8
with shredded
material as this could result in kickback of material
through the feed intake opening.
Stop and remove plug from the power sup-
ply.
After fully unscrewing the securing knob
3
, remove
cover
11
and clean the blade area. If debris is com-
pacted in the blade area, remove with a wooden or
plastic implement. Also clean the discharge chute
8
of any debris.
Branches become harder to shred depending on the
type, age and dryness of the wood.
For best results, shred fresh branches soon after
they have been cut.
The use of the prodder
13
will help with the feeding
of soft material.
Soft garden waste should be shredded in smaller
loads, particularly when wet.
Any blockages can be avoided by intermittently
shredding branches.
Assembly
Starting and Stopping
A
B
C
Shredding
Removing Blockage
Advice on Shredding
F 016 L69 923 - GB Seite 3 Mittwoch, 18. Juni 2003 2:57 14
14 • F 016 L69 923 • TMS • 13.06.03
