AUTODOME IP starlight 5100i IR
Installing a Parapet Roof Mount and Camera | en
31
Bosch Security Systems
Installation Manual
2021-02-19 | 0.7 |
10
Installing a Parapet Roof Mount and Camera
10.1
Installing the Roof Mount
1.
Determine the wall location on the roof for the camera and use the pendant parapet
mount bracket as a template to mark the hole locations.
i
Notice!
Allow enough room below the mount bracket to route the video, control, and alarm wires up
through the parapet arm. In certain installations, you may need to lift the parapet arm for the
camera to clear the top of the wall when it is swung into position. Provide enough slack in the
wires to rotate the pipe arm over the roof and back when camera maintenance is required.
2.
Prepare the mounting surface for the type of fastener by drilling holes for the mounting
anchors as required.
Figure 10.1:
Pendant parapet mount bracket and Roof mount plate
1
Pipe arm
4
Apply sealant around each fastener hole
2
Pendant parapet mount bracket
5
Roof mount plate
3
3/8-16 SS Hex Head Bolt
(supplied)
6
Use a minimum of six (6) fasteners (not
supplied). Eight (8) fastener holes shown.
i
Notice!
Fasteners are not supplied with the Roof Parapet Mount Kit because the appropriate
fasteners depend on the material to which the mount is attached. The material must
accommodate a minimum pull-out strength of 275 kg (600 lb) (for example, 19 mm (3/4 in.)
minimum for plywood). Fasteners can include bolts, studs, or lag bolts. All fasteners must be
made of corrosion-resistant stainless steel with a diameter of 10 mm (3/8 in.).
All bolts must fully extend through the mounting surface and be secured with a flat washer, a
lock washer, and a nut. All studs must be anchored to concrete or welded to a steel backing
plate. Anchor bolts can be used for blind structures where there is no access to the rear.
3.
Apply a weatherproof sealant around each fastener hole at the mounting surface.
4.
Attach the pendant parapet mount bracket using at least six (6) stainless steel fasteners,
three (3) on each side. (The bracket has eight (8) holes.) Be careful not to overtighten
the fasteners because it may strip the threads. If attaching the parapet mount to a flat
roof, attach the optional LTC 9230/01 Roof Mount Plate to the roof and then attach the
pendant parapet mount bracket to the Roof Mount Plate.
5.
Insert the Parapet Pipe Arm into the mounting bracket until it bottoms in the bracket.
