ARD-AYZ12
Installation Manual | en
7
Bosch Sicherheitssyteme GmbH
| V 1.2 | 2009.09
Figure 2
Installing the unit with the ARD-MPZ02 spacer
WIRING INSTRUCTIONS
The ARD-AYZ12 is supplied with an 18 inch (45 cm) pigtail,
having a 6-conductor cable.
To connect the reader to the controller, perform the following
steps:
1.
Prepare the reader cable by cutting the cable jacket back
1
1/4
inches (3,4 cm) and strip the wires
1/2
inch (1,3 cm).
2.
Prepare the controller cable by cutting the cable jacket
back 1
1/4
inches (3,4 cm) and strip the wires
1/2
inch
(1,3 cm).
3.
Splice the reader pigtail wires to the corresponding
controller wires and cover each connection with insulating
tape.
4.
If the tamper output is being utilized, connect the purple
wire to the correct input on the controller.
5.
Trim and cover all conductors that are not used.
Summary of Contents for ARD-AYZ12
