Bosch ARD-AYCE65B, Installation Manual

Page: 17 / 32

ARD-AYCE65B Reader Functionality | en 17
Bosch Sicherheitssysteme GmbH Installation manual | V 1.1 | 2009.08
Where:
5.3.5 Option No. 5: 1 to 5 Keys + Facility Code, 26-Bit
Wiegand
Buffers up to 5 keys and outputs keypad data with a facility
code like a 26-Bit card output.
The facility code is set in Programming Menu number four and
can be in the range 000 to 255. The factory default setting for
the facility code is 000. (See changing the Facility Code on page
22 for more information.)
The keypad PIN code can be one to five digits long and can
range between 1 and 65,535. When entering a keypad PIN code
that is less than 5 digits long, the # key must be pressed to
signify the end of PIN code entry. For keypad PIN codes that are
5 digits long, on the fifth key press of the 5 digit PIN code, the
data is sent across the Wiegand Data lines as binary data in the
same format as a 26-Bit Card.
If the ? key is pressed during PIN code entry or a PIN code
greater than 65,535 is entered, the keypad will clear the PIN
code entry buffer, generate a beep and is ready to receive a
new 5 digit keypad PIN code.
If the entry of the 1 to 5 digit keypad PIN code is disrupted and
no number key or # key is pressed within 5 seconds, the keypad
will clear the PIN code entry buffer, generate a medium length
beep and is ready to receive a new 1 to 5 digit keypad PIN code.
(EP) FFFF FFFF AAAA AAAA AAAA AAAA (OP)
Where:
EP = Even parity for first 12 bits
OP = Odd parity for last 12 bits
F = 8-Bit Facility Code
A = 16-Bit code generated from keyboard