Enclosures
Installation | en
5
Bosch Security Systems, Inc.
Installation Manual
2016.06 | 02 | F.01U.282.190
3
Installation
For enclosure details, see the following figure:
Figure 3.1: AE2 and AE4 enclosure features
1 Top enclosure mounting holes (2 per
enclosure)
2 Control panel\module mounting
locations
3 ICP-EZTS Tamper Switch mounting
holes (3)
4 Grounding pins for connection
enclosure cover to base
5 Grounding pin for connecting
transformer to base
6 Transformer mounting holes
7 Support post assembly
8 Possible printed circuit board
mounting locations
9 Screw to connect mounting clip or
mounting clip and printed circuit
board to enclosure
10 AE2/AE4 Enclosure standoff
11 Mounting location for lockset
12 Battery mounting location (two 7 Ah,
12 Ah, or 18 Ah batteries)
13 Knockouts for wiring
14 Bottom enclosure mounting holes (2
per enclosure)
3.1
Installing enclosure
To install an enclosure, follow these instructions:
1.
Knock out the desired wire entrances on the enclosure.
2.
Using the enclosure as a template, mark the top mounting holes on the mounting surface.
3.
Start installing the mounting hardware (as determined by surface and weight of
enclosure, modules, and batteries) for these two holes.
