aus
6
Rinse aid
As soon as the rinse-aid refill indicator
4
lights up on the control panel,
refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses.
Use only rinse aid for domestic dish-
washers.
Combined detergents with rinse-aid com-
ponent may be used up to a water hard-
ness of 21
_
dH (37
_
fH, 26
_
Clarke,
3,7 mmol/l) only. If the water hardness
is over 21
_
dH, rinse-aid must be used.
Open the dispenser
28
by pressing
and lifting the plate on the cover.
Carefully pour rinse aid up to the max.
mark in the filler opening.
Close cover until it clicks shut.
To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.
Setting amount of rinse-aid
The amount of rinse-aid dispensed can be
set from
to
. The factory setting
is
.
Do not change the amount of rinse-aid
unless streaks (select lower setting) or
water stains (select higher setting) are left
on the utensils.
Open the door.
Switch on ON/OFF switch
1
.
Hold down programme button A
and press START button
7
until on
the digital display is indicated
.
Release both buttons.
Press programme button A until the
factory set value
is indicated on
the digital display
8
.
To change the setting,
press programme button C .
Each time the button is pressed, the set
value increases by one level; when the
value of
has been reached, the
display jumps back to
(off).
Press START button
7
.
The set value is saved.
Close the door.
Switching off rinse-aid refill
indicator
If the rinse-aid refill indicator
4
is
impaired (e.g. when using combined
detergents containing rinse-aid
component), it can be switched off.
Proceed as described under “Setting
amount of rinse-aid” and set the value
to
.
The rinse-aid refill indicator
4
is now
switched off.