aus
15
Timer programming *
* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
Open the door.
Switch on ON/OFF switch
1
.
Press
5
+ button until the digital
display
8
jumps to
.
Press
5
+ or – button until the
displayed time corresponds with
your requirements.
Press START button
7
, timer
programming is activated.
To delete timer programming, press
the
5
+ or – button until
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
Close the door.
End of programme
The programme has ended when the
value
is indicated on the numerical
display
8
.
The end of the programme is also
indicated by an acoustic signal.
This function can be changed as follows:
Open the door.
Switch on ON/OFF switch
1
.
Hold down programme button A
and press START button
7
until on
the digital display
is indicated.
Release both buttons.
Press programme button A until the
factory set value
is indicated on
the digital display .
To change the setting,
press programme button C .
Each time the button is pressed, the set
value increases by one level; when the
value of
has been reached, the
display jumps back to
(off).
Press START button
7
, the set value
is saved.
Close the door.
Switching off the appliance
Short time after the end of the programme:
Open the door.
Switch off ON/OFF switch
1
.
Turn off the tap (not applicable
if Aqua-Stop fitted).
Remove the utensils when they have
cooled down.
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
Open the door.
Switch off ON/OFF switch
1
.
The LEDs go out. The programme
is saved.
If the door was opened on an appliance
which has a warm water connection
or is heated, first leave the door ajar
for several minutes and then close.
Otherwise, expansion (pressure) may
cause the appliance door to spring
open or water to run out of the
appliance.
To continue the programme, switch
on the ON/OFF switch
1
again.
Close the door.
Terminating the programme
(Reset)
Open the door.
Press START button
7
for
approx 3 sec.
is indicated
on the digital display
8
.
Close the door.
The programme sequence lasts
approx. 1 min.
is indicated on the digital
display
8
(buzzer sounds).
Open the door.
Switch off ON/OFF switch
1
.
Close the door.
