Bosch 200 C, Original Instructions Manual

Page: 47 / 385

English | 47
<Object View>
The <Object View> offers the best possible measuring results and the maximum meas-
uring depths. The detected objects are displayed over the measuring path with depth in-
formation and, if available, with material properties.
Measuring process:
– Place the measuring tool on the substrate and move it over the substrate in the direc-
tion of travel. The measuring results are shown on the display after a minimum meas-
uring path of approx. 10 cm.
– Always move the measuring tool in a straight line while applying light pressure over
the substrate so that the wheels remain in contact with the wall.
– To obtain optimum measuring results, move the measuring tool slowly over the entire
area to be checked and observe the measuring results as you move the tool back. The
measuring path should be at least 40 cm.
– You can start a new measurement at any time by pressing the red start button (16) .
– If you lift the measuring tool away from the wall during the measuring process, the last
measuring result obtained remains on the display. The measurement is restarted
when the device is set down or moved.
The tool's function allows for reliable detection of the nearest edges of objects that run
transverse to the direction of movement of the measuring tool (see figure
C ). For this
reason, always move crosswise over the area to be checked.
To locate objects, moving the measuring tool once over the measuring path is sufficient.
To identify the exact location of a detected object and to mark the object, move the
measuring tool back over the measuring path.
The direction of a found object in a wall can be determined by moving along several off-
set measuring paths one after another.
Bosch Power Tools 1 609 92A 5L5 | (11.01.2021)