May-19
Product Code: BTJ35TA
Made in China to TQB Brands Pty Ltd specifications
Page 5
Visit us at www.tqbbrands.com.au
4.
OPERATION
Lifting
1.
Attach air supply hose to fitting in handle control valve. (110 -125 PSI / 14 cfm).
2.
Position the jack in accordance with the vehicle manufacturer's instructions. Centre
load on saddle.
3.
Rotate control valve clockwise and hold to raise the piston, release control valve
when desired height is reached.
4.
WARNING: During lifting ensure load and jack remain stable, if either appear to be
unstable, stop lifting load and reposition jack.
5.
IMMEDIATELY after reaching desired height, secure load with appropriately rated
safety stands (refer to vehicle manufacturer's recommended positioning)
Lowering
1.
Ensure air supply line is connected and air compressor is turned on, raise the load
enough to remove safety stands.
2.
WARNING: Ensure load does not shift or become unstable when lifting. If load is
unstable, slowly lower load back on to the safety stands. Correct instability and try
again.
3.
Carefully remove the safety stands.
4.
Turn the control valve counter clockwise just enough to allow controlled descent.
Lower load slowly.
5.
Once fully lowered, release control and remove jack.
CAUTION
Heavier loads will lower very quickly, use extra caution when turning the release
valve to lower the load.
5.
INSPECTION
Prior to each use conduct a visual inspection checking for abnormal conditions, such
as cracked welds, leaks, and damaged, loose, or missing parts.
The jack shall always be maintained in accordance with the maintenance instructions
(Section 7). No alterations or modifications shall be made to this Jack.
Inspections shall be performed in accordance with this owner’s manual.
The jack must be inspected immediately if it is believed to have been subjected to
abnormal load or shock.
Owners and /or operators should be aware that repair of this product may require
specialised equipment and knowledge (refer to maintenance section).
6.
STORAGE
This jack should always be stored in a dry location on a level surface with the lift ram
pistons in the fully retracted position, where it will not be exposed to corrosive vapours,
abrasive dust, or any other harmful elements.
