05/20
BBJ50TA
Made in China to TQB Brands Pty Ltd specifications
P a g e
|
4
Visit us at www.tqbbrands.com.au
Bleed Air for Air Motor:
1.
Remove the Oil Filler Bung and if required, refill with *32 Grade hydraulic
oil until the oil is lapping the bottom of the Oil Filler Hole.
2.
Leave the Oil Filler Bung out, turn the Release Valve ‘clockwise’ to the lift
position and pump the Pump Socket ‘up and down’ to raise the Lift Ram to
full extension.
3.
Replace the Oil Filler Bung, then turn the Release Valve ‘anticlockwise’ to the
lowering position until the Lift Ram returns to the fully lowered position.
(Note: Depress the Saddle where necessary)
4.
Turn the Release Valve ‘clockwise’ to the raise position. Connect an air supply
to the Air Trigger assembly and depress the trigger, holding down until the
Lift Ram is fully extended.
5.
Remove the Oil Filler Bung, then turn the Release Valve ‘anticlockwise’ to the
lowering position until the Lift Ram returns to the fully lowered position.
(Note: Depress the Saddle where necessary)
6.
Replace the Filler Bung and turn the Release Valve ‘clockwise’ to the raise
position. Connect an air supply to the Air Trigger assembly and depress the
trigger, holding down until the Lift Ram has extended to full stroke then...
...continue to hold the trigger down for 10 seconds.
7.
Turn the Release Valve ‘anticlockwise’ to the lowering position until the Lift
Ram returns to the fully lowered position. (Note: Depress the Saddle where
necessary)
At this point the Manual Pump, Air Motor Pump and Lift Ram should be free of air and
the Jack ready for Operation.
If the Jack continues to show the Symptoms as above, please refer to a Qualified
Hydraulic Technician.
3.
OPERATION
Prior to each use always conduct a visual inspection checking for and any abnormal conditions, such
as cracked welds, and damaged, loose, or missing parts.
Raising the Jack:
1.
Block the vehicle's wheels for lifting stability. Secure the load to prevent inadvertent shifting and
movement.
2.
Position the jack near desired lift point.
3.
Set the parking brake in the vehicle.
4.
Refer to the vehicle manufacturer owner's manual to locate approved lifting points on the vehicle.
Position the jack so the saddle is centred and will contact the load lifting point firmly
5.
Assemble the handle; ensure that spring clips align with slots.
6.
Close the release valve by turning it clockwise until it is firmly closed.
Handle
(on Release Valve)
Pump
Socket
Saddle
Air
Motor
Oil Filler
Hole
Relief
Valve
Oil Filler Bung
Air
Fitting
Pump
Socket
Lift
Ram
Oil Filler Bung
Oil Filler Bung
Lift
Ram
Air
Trigger
Oil Filler Bung
Lift
Ram
Oil Filler Bung
Oil Filler Bung
Lift
Ram
Air
Trigger
Oil Filler Bung
