Product Code: BAJ2080
Made in China to TQB Brands Pty Ltd specifications
Page 5
Visit us at www.tqbbrands.com.au
5.
OPERATION
1.
Verify the control level is in the neutral position.
2.
Connect compressed air supply to the jack. (Compressed air should be clean, dry,
and regulated at 100-145psi). Install an air filter/lubricator in the shop air line,
because water in the air line will damage the jack.
3.
Make sure the jack and vehicle are on a hard level surface.
4.
Always set the vehicle parking brake and block the wheels.
5.
Move the control lever to UP to raise the saddle to the contact point. Move the
control level to neutral position.
6.
Check the placement of the jack. The load must be centered on the jack saddle.
Avoid jack wheel obstructions such as gravel, tools, or uneven expansion joints.
7.
Position the jack under the vehicle using the manufacturer's recommended lifting
points on the chassis.
8.
Move the control lever to UP to finish lifting the vehicle.
9.
Always immediately position approved jack stands under the vehicle at points that
will provide stable support in accordance with the vehicle manufactures
recommendations.
10.
Always lower the vehicle slowly onto the jack stands by pushing the control lever to
the DOWN position.
6.
INSPECTION
Prior to each use conduct a visual inspection checking for abnormal conditions, such
as cracked welds, leaks, and damaged, loose, or missing parts.
The jack shall always be maintained in accordance with the maintenance instructions
(Section 7). No alterations or modifications shall be made to this Jack.
Inspections shall be performed in accordance with this owner’s manual.
The jack must be inspected immediately if it is believed to have been subjected to
abnormal load or shock.
Owners and /or operators should be aware that repair of this product may require
specialised equipment and knowledge (refer to maintenance section).
7.
STORAGE
This jack should always be stored in a dry location on a level surface with the lift ram
pistons in the fully retracted position, where it will not be exposed to corrosive vapours,
abrasive dust, or any other harmful elements.
