BorMann PRO BCP3000, Owner'S Manual

Page: 9 / 17

4
www.BormannTools.com
d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or
these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other
condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many
accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind
and are easier to control.
g)
Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the
working conditions and the work to be performed. Use of the power tool for operations different from those
intended could result in a hazardous situation.
Service
a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure
that the safety of the power tool is maintained.
How to use the Polisher
Before setting up, repair or maintenance of the appliance you must always turn off the operating switch
and pull out the mains plug!
Before Initial Operation
- Check if the rated frequency of the mains supply corresponds to the details of the type place.
- Before using the tool, read the instruction book carefully.
Starting the Unit
Ensure that the data listed on the nameplate concurs with the mains voltage before connecting the unit up.
On / off switch
Power on by pushing the switch button (1) to the left side.
Power off by opposite action.
Variable Speed
Press button (3) to increase the speed and button (4) to decrease the speed.
Please note: The No displayed on LED (2) will be 0,10,15,20,25 and 30 which represent the speed is
0,1000,1500,2000,2500 and 3000rpm respectively.
Assemble and Disassemble the Polishing Pad
Press the spindle lock (5) by one finger meanwhile turn the pad for assemble and disassemble purpose by the other
hand.
Care and maintenance
Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance. Always store your power tool in a dry place.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
If a fault cannot be rectified, return the mixer to an authorized dealer for repair.
Cleaning
• Keep the safety devices, ventilation slots and Motor housing as free of dirt and dust as possible. Clean the unit by
rubbing it with a clean cloth or blow it clean using low-pressure compressed air.
•
We recommend that you always clean the unit immediately after using it.
•
Clean the unit regularly by rubbing it with a damp cloth and a little soft soap.
•
Do not use cleaners or solvents; these will attack the plastic parts in the unit.
•
You must also ensure that water cannot get into the inside of the unit.