3
www.BormannTools.com
GB
Instructions
1)
Check the machine when you open the carton. Please reinforce the screw which may be loose during the
transportation. Check the bottom disk and drive belt, please adjust the belt if the tightness is not suitable.
2)
Put the machine on the flat ground, and let the machine race empty for 3
-
5 minutes to make sure there is no problem
of the machine.
3)
Try to make the cut as small as you can when bleeding the chickens (better to thrust the chicken’s neck with the
cone
-
knife, which will prevent the chicken’s head
from dropping off in depilating). After bleeding, put the chicken
in warm water
（
30
℃
—
50
℃
）
,make sure all the feather are wet out, It is better to put some salt into the water
which can protect the skin away from damage.
4)
Put the wetted chicken in the hot water(75
℃
), churn slowly to hot all the feather
5)
Turn on the machine; Put the hot chicken, 10
-
15 heads at one time. During depilating, please put some water onto
the chicken(hot water better), the feather will be washed away and run out of the machine with the dirty water
6)
The feather will be all clear out after 40
-
60 seconds, turn off the machine and get out the chicken while the machine
stop racing.
7)
It is better to depilate the chicken immediately after bleeding. The effectiveness will be not good if the chicken stay
dead for long time
Notice
1)
for your safety, please install leakage protector and link safety ground line
2)
main power supply should be higher than the machine supply
3)
Never touch the machine with wet hand
Drawing
Technical Data
Depilation net rate:
95%
Net Weight:
38K g
Gross Weight:
42K g
Motor speed:
275r/min
Motor Power:
1500W
Barrel diameter:
50cm
Material:
403 stainless steel
Suitable for:
Chicken, goose, duck
