EN
WWW.BORMANNTOOLS.COM
4
Lubrication
This equipment will not operate safely without proper lubrication. Using the equipment without proper lubrication will result in poor performance and damage
to the equipment. Some parts of this equipment are not self-lubricating
Inspect the equipment before use and lubricate when necessary. After cleaning, lubricate the equipment using-light
Penetrating oil, lubricating spray.
• Use a good lubricant on all moving parts.
• For light duty use lubrication once a month.
• For heavy and constant use lubrication recommended every week.
• NEVER USE SANDPAPERS OR ABRASIVE MATERIALS ON THESE SURFACES!
Rust Prevention
Check rams and pump plungers on the power unit assemblies daily for any signs of rust or corrosion.
Without a load lift the equipment as high as it goes and look under and behind the lifting points. If signs of rust are visible clean as needed.
Grease Fittings
Some models contain grease fittings the will regularly need to be greased and lubricated.
Storage
1. Lower the hydraulic ram to lowest position.
2. Leave lowering valve open.
3. Store in a dry location, recommended indoors.
Note: if the jack is stored outdoors, be sure to lubricate all parts before and after use to ensure the jack stays in good working condition. Always store jack in
the fully retracted position when stored in outdoor or caustic environments that can cause corrosion and/or rust.
