BorMann BSC6000, Operator'S Manual, Page: 11 / 13

www.BormannTools.com
Amp Hour Rating o f Battery × Percent of Charged
Needed = Hours to Charge
Amp Setting Selected On Charger
d. If the battery is rated in Reverse Capacity, use the following formula to convert
reverse capacity to amp - hours.
Reverse Capacity
+ 15.5 = Amp - Hour Rating
2
NOTE: The length of charge times are approximate and vary from the battery to
battery. Always follow the battery manufacturer ’ s specific charging instructions.
21. OPERATING INSTRUCTIONS
Before using review all safety and connection directions before using charger.
Failure to do so can damage battery and cause serious injury or death.
FEATURES:
Features
LCD screen display the charging function
— LCD display
—
6V Motorcycle mode
—
6V Motorcycle snow mode
— 12V Motorcycle mode
— 12V motorcycle snow mode
— 12V vehicle mode
— 12V vehicle snow mode
— Battery voltage
— Error 1
— Error 2
— FULL
— Display charging status
SELECT MODE switch use :
6V motorcycle
mode(2 A
）
— Use this setting for charging large 6volt batteries
6VMotorcycle
snow
mode
（
2 A
）
— Use this setting for charging small 6 volt
batteries in winter.
12V Motorcycle
mode
（
2 A
）
— Use this setting for charging 12 volt batteries
12V Motorcycle
snow
（
2 A
）
— Use this setting for charging large 12 volt
batteries in winter.
12V Vehicle
mode
（
4 A
）
— Use this setting for charging small 12 volt
batteries
12V Vehicle snow
mode
（
4 A
）
— Use this setting for charging 12 volt batteries in
winter.
Charging:
·
Connect the charger to battery and AC power per instructions in sections 16 & 17
or 18.
·
Select the appropriate charger voltage for your batter
·
Connect the charger to the AC power, the POWER Led will be on; If the clamps are not
connected to the battery, or reverse connected, or the vehicle battery voltage is less than
0.5V, the Error1 Led will be on, otherwise the Error 1 LED will be not on.