4
www.BormannTools.com
4) Always check if the components of the tool are fixed well.
5) The housing should be without trace of crack or damage.
6) Always check if the cable is without damage
7) Keep the motor ventilation slots clean; Keep all working controls free of dust.
8) If you see some sparks flashing in the ventilation slots, this is normal and will not damage your power tool.
Replacing the carbon brushes
Replacing the carbon brushes, when the tool could not run or too much sparkle.
Carbon brushes which are which out (burned, broken or shorter than 5 mm) have to be replaced by new one.
Always replace both carbon brushes at the same time and use the brush by original manufacturer.
Because the carbon brush is internal, so please change the brushes by our maintenance service center.
After placing the new carbon brushes, let the tool run for some minutes so that the brushes fit better.
Repair
Please only use accessories and spare parts recommended by the manufacturer. If the tool get malfunction, please hand over
the tool to our dealer or appointed maintenance station. Don’t disassemble the tool by yourself or replace the parts supplied
by other factories.
Technical Data
Voltage/Frequency:
230V/50Hz
Input power:
850w
No load speed:
850rpm
Chuck type:
16mm w/with key
Max drilling capacity concrete/steel/wood:
13/10/30mm
