3
www.BormannTools.com
•
Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that
may affect the power tool's operation. If damaged, have the power tool repaired before use. Many accidents are caused by
poorly maintained power tools.
•
Keep cutting tools sharp and clean.
•
Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
•
Use the power tool, accessories and tool bits etc., in accordance with these instructions, taking into account the working
conditions and the work to be performed. Use of the power tool for operations different from those intended could result
in a hazardous situation.
Service
Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
Additional safety regulations
The following listed points are the safe regulation for drill. Please read and must obey, otherwise the tools could be damaged
and cause injury to user.
a) The drilling bits must be correctly and well fixed on the chuck
b) Before turning on the drill, please make sure that the drilling bits is not touching other objects.
c) The person with long hair should take hair cover to avoid and danger by twisting.
d) When using the drill, please do not touch the drilling bit with your finger, even with glove.
e) Please do not touch the drilling bit to wire to electricity, water pipe or pipe of gas cooker when working on the wall, floor
or similar place. Do not touch the drilling bit on to metal objects.
f) Please do not let drilling bit touch the cable of tools, otherwise it cause damage to cable.
g) Please do not lay down the drill from hand before turn it off.
h) Do not touch the drilling bit at once after working because the bit could be very hot and cause injury to your hand.
i) Please use the same type of extended cable with double insulation if you need.
Additional safety warnings
a) Wear ear protectors. Exposure to noise can cause hearing loss.
b) Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal injury.
Operation instructions
1)
Assemble and disassemble the drilling bits
P
lace
the chuck onto spindle
, align the hole of the chuck with the spindle and
apply force to fix it on
. Put the drilling bit
into the hole of chuck. Then screw chuck
tightly. If it is a key chuck, you should use a
special spanner to screw the chuck
clockwise till it tightly. (Figure 1.)
To disassemble the drilling bits by screwing chuck anticlockwise.
2)
Switch
Warning: Before installing or disassembling the disc, Please make sure the switch is
in "OFF" position and the Plug is not connected with socket.
Press the switch button, then the drill runs.
Releasing the switch, then it stops. (Figure 2.)
If you need to lock the switch, then press the lock- on button when switch on, the
drill could keep running, Press the switch button again, it stops.
1) Always disconnect the tool before carrying out inspection or cleaning.
2) Never use water or chemical cleaners to clean your power tool, wipe clean with a dry place.
3) The air-vent of the tool should be cleaned regularly to avoid the motor too hot due to air-vent blocked.
