18
5.1 Switching on and off (B6)
To switch on:
Press the control switch (2).
To switch off:
Release the control switch (2).
Switching to continuous operation:
Press the ON/OFF switch and lock it in this
position with the locking switch .
Switching off continuous operation:
Press the ON/OFF switch and release it
again.
5.2 Practical tips
5.2.1 Sharpening chisel tools
You will only achieve good results if you use
sharp chisels. You should therefore sharpen the
chisels promptly to ensure that they produce
good results and provide a long service life.
Important.
You only require slight contact pressure for
chiseling.
Excessive contact pressure will place an
unnecessary strain on the motor. Check the
chisels at regular intervals. Sharpen or replace
blunt chisels.
6. Technical data
Mains voltage: 230 V~/50 Hz
Power input: 1700 W
Blow rate: 1850 /min
Protection class: II /
Weight: 15.9 kg
Chiseling
Vibration emission value a
h
= 18.575 m/s
2
K uncertainty = 1,5 m/s
2
Sound pressure level L
pA
: 92.87 dB(A)
Uncertainty K
pA
: 3 dB
Guaranteed sound power level: 105 dB(A)
Wear ear-muffs.
The impact of noise can cause damage to
hearing.
Total vibration values (vector sum of three
directions) determined in accordance with EN
60745.
Important!
The vibration value
changes according to the area of
application of the electric tool and
may exceed the specified value in
exceptional circumstances.
7. Replacing the power cable
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
aftersales service or similarly trained personnel to
avoid danger.
8. Cleaning, maintenance
Always pull out the mains power plug before
starting any cleaning work.
8.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
• We recommend that you clean the device
immediately each time you have finished using it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can
seep into the device.
8.2 Carbon brushes
• In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important!
The carbon brushes should not be
