BorMann 036418, Quick Start Manual, Page: 6 / 15

EN
WWW.BORMANNTOOLS.COM
6
1. Indicator lamps
2. Check button
Indicator lamps
75% to 100%
25% to 50%
10% to 25%
Lit
GREEN
ORANGE
RED
ORANGE
RED
RED
Remaining
capacity
Off
NOTE: Depending on the conditions of use and the ambient temperature, the
indication may differ slightly from the actual capacity.
Switch action
CAUTION: Before installing the battery cartridge into the tool, always check to see
that the tool is switched off.
NOTICE: Do not turn the power switch forcibly. This may cause the switch to mal-
function.
NOTICE: Always set the power switch to the "O" side when not using the cleaner
for long time.
1. To start the tool, Press down the power switch toward the “I (ON)” position.
2. To stop the tool, Press down the power switch toward the “O (OFF)” position.
1. Power switch
Carrying handle
NOTICE: Always be sure that the tank cover is locked firmly by the buckle before
carrying the tool.
When carrying the cleaner, carry it by holding the handle on the head.
Assembly instructions
CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool.
CAUTION: Always wear dust mask during assembly or maintenance.
Replacing the powder filter assembly (HEPA) and disposing of dust
NOTE: Always remove dust ahead of time, as the suction power will be reduced if there is too much dust in the cleaner.
NOTICE: Always be sure to check that the powder filter is loaded correctly prior to using the cleaner. If it is not loaded correctly, dust will get into the motor
housing, and cause a motor failure. If the following examples occur, the powder filter is not loaded correctly. Reload it correctly to rectify problem.
To remove the powder filter assembly, perform as follows:
1. Pull up the buckle on both sides of the tool to release them.
2. Pull forward a little to hook off the two buckle completely.
3. Separate the head assembly from the tank and clean out the dust in the tank completely.
4. Pull forward a little hard to separate the powder filter assembly and lightly tap it to remove dust or replace with a new one. If it’s difficult to remove the
dust, you can use a blow machine to remove it.