EN
WWW.BORMANNTOOLS.COM
8
LED Work-light (Fig.10)
To aid use in confined, and inadequately it spaces; the LED work-light 4 automatically illuminates when the trigger is activated
Screwdriving
To prevent slip or damage to the screw head, match the screwdriver bit to the screw head size.
To remove screws:
Move the direction switch to the reverse position and pressure to tie screw head and press the trigger slowly.
Screwdriver bits are consumable items.
Warning!
Before drilling check that there are no hidden hazards such as electrical cables, water or gas pipes running below the surface
by use of a metal voltage detector.
Do not expose either the drill or charger to rain or water.
Do not overcharge the battery pack (more than six hours) as this could damage the battery cells.
Drilling Wood And Plastic (Fig.11)
To prevent splitting around the drill holes on the reverse side, clamp a piece of scrap timber (A) under the material to be
drilled.
Drilling Metal (Fig.12)
Metals such as mild steel, aluminium and brass may be drilled.
Mark the point to be drilled with a centre punch (B) to help the drill bit tip to locate.
A drop of oil (C) on the drilled area will aid cutting and help prolong the life of the bit.
Note: Although metal drilling is technically within the capabilities of this drill, its rotational speed is not always fast enough to
achieve perfect results every time. For this reason, extra caution should always be taken when drilling metal, as snagging of
the drill may occur.