BorMann 022749, Owner'S Manual, Page: 12 / 17

6
www.BormannTools.com
Graphic symbols and technical data
Operation
Step1:
Use ground clamp to connect the grounding cable and work piece or connect the metal carriages (as work table) make
sure the clamp has been contacted fully with work piece and clear the rust and paint.
Step2: Check the position of power switch, position must be on "OFF, then insert the inlet wire to the socket (voltage is
230VAC, rated current of socket 15A).
Step3: Discharge the nozzle cover and contact tip at the head of welding torch, pull the soft pipe.
Step4: The welding tongs that clamp the rod can't be contacted with any grounding objects then turn the conversion switch
to voltage position (the same with input voltage) the power lamp (green) will light.
Step 5:
Press (and hold) the torch button until distance between wire and welding torch is 30mm loosen torch button.
Step6: Close the power; fix the contact tip and nozzle cover onto the welding torch. (Wire must through the contact tip and
nozzle cover)
Step7:
Open the power, press the switch spasmodically, adjust the speed by turning the adjusting wire feed speed knob.
Step8: Orient yourself on the area to be welded, and then place the Face Shield over your eyes.
Step9: Press (and hold) the torch button and stroke the area to be welded with the electrode wire to ignite the arc.
Step10:
Once the arc is ignited, tilt the electrode wire forward at an angle of approximately 35°. (As diagram 3-3)
Diagram 3-3
Step12: When the weld is complete, lift the electrode wire clearly away from any grounded object, set the Face Shield down
and turn the Power Switch to the "OFF" position.
Step13:
Unplug the Power Cord from the electrical outlet.