![BorMann 019084 Owner'S Manual Download Page 23](http://html.mh-extra.com/html/bormann/019084/019084_owners-manual_2788850023.webp)
23
www.BormannTools.com
OPERATING INSTRUCTIONS
WARNING:
THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY! DO NOT
USE HOT WATER IN THIS PRESSURE CLEANER!
WARNING:
High pressure hose must not loop.
Warning-danger!
During operation the appliance must be positioned on a firm,stable surface.
Starting Up
Warning:
ALWAYS turn off the unit's motor BEFORE turning off the unit's water supply.
Serious damage could occur to the motor if the unit is run without water.
1. Turn on the water supply tap fully.
2.Unlock trigger (by pressing the safety button first and then actuate the trigger) for a few
second ; let the water flow out from the nozzle.
3. Check if water leaks from joints. If water leaks, please reconnect the
water hose, the spray
gun or the lance to make sure each accessory are connected perfectly.
4. Connect to power supply.
5. Set the power switch at the position "I".(Fig.1)
6. Actuate the trigger and start the washer. Fig.1
WARNING! Check that the supply voltage and frequency correspond to those
specified on the appliance data plate. The appliance should only be connected to a
mains power supply via a security breaker (Max.30mA) to cut off the electricity
supply in the instance of a short circuit.
Stopping the washer
Warning:
ALWAYS turn off the unit's motor BEFORE turning off the unit's water supply.
Serious damage could occur to the motor if the unit is run without water.
1. Release the t
rigger,the motor will stop operation.
2. Set the switch at the position" O".(Fig.1)
3. Disconnect the plug from the socket.
WARNING! Failure to follow the above instructions may cause damage to the
machine.
Changing accessories
1. Release the trigger.
2. Turn off the power switch (the position" O").(Fig.1)
3. Disassemble the original
adjustable Nozzle.
4. Mount the adjustable Nozzle and Detergent Bottle.
CAUTION:
Never disconnect the high -pressure discharge hose from the machine while the
system is still
pressurized . To depressurize the unit, turn off the motor,turn off the water
supply and squeeze the trigger 2
-3 times.