fault finding
Machine does not work
•
Check mains plug is in socket and mains supply is on.
•
Machine is not switched on at rocker-switch ( 11 ).
•
Stop-switch at the slide carriage is defective.
Attention :Work on electrical equipment on the machine must only be performed
by a skilled electrican.
Power is on but cutter will not rotate (machine is connected to power
supply)
•
Disconnect belt cover and brush.
Check belt is connected or defective.
Check if pully wheel will turn.
Check if motor axle will turn.
Belt is defective
•
Change belt. Use only genuine belts.
Loosen 4 nuts under body of machine and reposition motor until belt fits on both
pully wheels. Push motor back to old position and ritighten nuts.
Not possible to turn the motor- and/or cutter-axle
•
Please contact our technical-service.
Work-light does not work
•
Check if plug is in socket and turned on.
Check lamp balast.
Work-light is defective
Change the bulb only when machine is switched off.
Cutter is noisy, bad cutting quality or machine is out of adjustment
•
Change cutter (see page 6) Check adjustment of machine (see page 10).
Imossible to release the slide-carriage to feeler and cutter
Please check if alignment gauge axle is at „park-position“.
If yes, please contact our technical-service.
In case of any other faults please contact our sales department.
Tele.: 02332/7006-0
13
