BORK Z 780, Instruction Manual

Page: 7 / 13

10 11
LOAD CARRIAGE CLEANING
• Remove the load carriage by pressing
the carriage lock.
• Wipe the load carriage with a damp cloth
or rinse under running water.
• Wipe guiding parts with a damp cloth
and grease them with the petroleum jelly
or a similar lubricant.
Lubricate guide parts once a month using
a few drops of oil that does not contain
tar, or petroleum jelly. Remove excess oil
or petroleum jelly with a soft cotton cloth.
• Hold the carriage lock, insert the carriage
and slide it forward along the guides.
STORAGE
It is recommended to store the device in
assembled condition in a cool dry place, away
from acids and bases, at a temperature from
5 to 30°C and relative humidity of 65%.
The device is equipped with a compact storage
section for the power cord.
The device can be folded into a compact case
which can be stored in a drawer or in a kitchen
cabinet.
• Please read this manual before using the
device. Not following the guidelines in this
manual may lead to personal injury and/or
damage to the user’s property.
• Before turning on the device make sure
that characteristics of the power outlet
correspond to those indicated on the
product rating label.
• It is prohibited to remove or damage the
information plate/label of the device and
its serial number. It is necessary for device
identification in the event of a malfunction.
• Do not touch the edges of the knives since
they are very sharp and can cause serious
injury.
• Do not allow any foreign bodies and/or
liquids to enter the housing of the device,
since it can lead to the device damage.
• It is prohibited to immerse the device, its
cord or plug into water or other liquid.
• The slicer is designed for home use.
• It is prohibited to use the slicer outdoors
or in moving vehicles.
• Do not move the slicer during operation.
• Do not let the power cord hang from edges
of tables, do not lay it over heated surfaces,
and do not allow the cord get tangled.
• Always unplug the power cord from the
power outlet when leaving the slicer
unattended and after its use.
• Always unplug the power cord from the
power outlet prior to assembly, disassembly,
cleaning and prior to transfer to storage.
• Check the power cord, plug and housing
regularly for damage. In case of any damage
immediately stop using the slicer and bring
it to the nearest BORK service center.