BORK C806, User Manual

Page: 12 / 19

20 21
• Do not operate the coffee station in areas with high
humidity and at temperatures below 0°C. In cases of
transportation or storage of the device carried out at
negative temperatures with subsequent transfer to
warm premises it is necessary to keep the device
indoors for at least
4 hours.
• Do not allow foreign bodies and liquid to enter the
device housing, since such measure can lead to
damage.
• The portafilter sealing element and water container
sealer have normal wear and tear, their service life
depends on the application frequency and accuracy
of handling.
• Transportation of the device shall be allowed only in
the original packaging, as well as in the upright
position.
• The device shall be disposed in accordance with law
requirements of the country, in which it is used.
• It shall be prohibited to use steel wools, abrasive
sponges, chemicals, abrasive cleaning agents for
cleaning of the device,
including equipment which can cause damage and leave
scratches.
• Display application with non-completely clean hands
becomes problematic because of difficulties related
to movement of fingers, as well as due to resulting
fingerprints and stains.
CORRECTIVE MEASURES
•Iit is necessary refer to the section
"Troubleshooting" in case of faults in device
functioning. If it is not possible to fix the problem -
immediately stop using the device
Refer to the nearest BORK service centre for testing,
replacement or repair.
•For safety reasons, all procedures on repair and
maintenance of the device shall be performed only in
authorized BORK service centres. Addresses and
telephone numbers of service centres can be found
on the site www.bork.ru or using the phone number
8 800 500 88 99.
TROUBLESHOOTING
Try to find the cause of a problem and ways to solve it, following the recommendations below if there are any difficulties arising during operation. Contact the BORK service
centre if you still have unresolved problems or questions.
Problem Possible cause Troubleshooting
Coffee does not pour out or pours out too slowly,
dripping
There is no water or too little water in the container. Fill the water container to the required mark.
The coffee grind type is too fine
Adjust the degree of grinding. It is recommended to begin from the 10 setting.
If you are using ready-made ground coffee, then it is necessary to make sure that the
grind is suitable for automatic espresso coffee stations.
Too much ground coffee in the filter Apply the automatic dosing function
Coffee is pressed too tight Press the coffee with less pressure
The portafilter has been clogged Clean the portafilter
Excess lime deposits Complete the descaling procedure