BORG LOCKS (UK) LTD
9, Upminster Trading Park, Warley Street, Upminster, Essex, RM14 3PJ
T: 44 (0)1708 225700 F: 44 (0)1708 226338
Easicode Pro (ECP) Instructions V4
The following instructions are applicable for all 2000 ECP models.
The code should be changed with the door in the open position. To change the code you will need to
know what the keypad is currently set to. The code can be changed with the unit fitted on/off the
door.
1. Enter existing code
2. Using code change key - insert into the hole in the * button - fully press and hold until step 5
3. Press `C` button to clear the existing code
4. Enter the new code
5. Release the code change key from the hole in the * button
6. Press `C` to set the new code
7. The new code is now set and ready for use
8. Check that the code is working 5 times and that it is withdrawing the latchbolt in the door before
closing the door.
Please note: If a mistake is made whilst entering a new code (with the * button pressed) the `C`
button can be pressed which will cancel any buttons that have been pressed and you can start
again.
Fitting & positioning the spindle
Non key override models
When positioning the spindle ensure that the spindle is facing towards the top opening edge of the
door (as per fig.1 overleaf) when viewed from the outside (keypad side) of the door. Use the longest
spindle supplied to ensure that it does not move out of position when fitted to the door.
Further fitting & positioning the spindle instructions overleaf
Code Change Key
