Borg & Overström
GB
13
Install & Operation Manual
1
Remove the 3 screws holding
the unit lid down and lift the
lid away
Locate the flow control adjuster,
this can be found on top of the
carbonator can, connected to
the central port of the can.
Loosen the lock nut, but do
not remove.
Flow can then be adjusted
by turning the adjuster screw,
anti-clockwise to increase flow
and clockwise to restrict flow.
After each adjustment the flow
rate should be timed.
Sparkling Water Flow Rate - Sparkling Versions Only
NOTE:
The soda water flow rate is set to 35ml/sec at a CO2 pressure of 58 PSI (4 bar). To
adjust the soda water flow rate follow these steps:
Once the correct flow rate is achieved reverse steps 1, 2 and 3.
C
2
C
3
4
C
