Tracer
Boost Technology
Page 9 of 13
Installing or Removing the Batteries
Refer to the figure while following the directions below:
1.
From the top of the mouse, slide the battery cover open by pushing firmly with your thumbs as shown in
1
, above.
2.
Remove the existing battery if necessary. Connect the replacement battery to the mouse. The plug is designed to fit
in one way only: carefully align the tabs on the battery plug with the slots on the transmitter socket. Gently push
battery connector until it snaps into place, as shown in
2
, above. DO NOT FORCE.
3.
Place the battery pack in compartment, replace the cover as shown. Make sure wires do not interfere with the battery
cover when closing (
3
and
4
, above)
4.
Charge the battery overnight by placing Tracer on the receiver cradle before its first use. The LED on the mouse
slowly flashes to indicate it is charging. When fully charged, the LED glows a solid green and Tracer is ready for
use.
Recharging
Tracer NiMH batteries can hold a charge for approximately 10 hours of continuous use. However, it is recommended that you place
Tracer in its receiver/recharger cradle whenever you leave your desk for any length of time. If the Tracer battery is extremely low on
charge, the LED on the transmitter will slowly blink. The LED goes dark if the battery is discharged.
