E
INSTRUCTIONS:
The narrow end of NAKED is
intended for newborns in a reclined
position.
NOTE
The tub was designed with a
large range of children in mind. If you
find your child slipping in the recline
position, it may be beneficial to place
a small towel or sponge at the bottom
of the tub.
The wider end of NAKED is intended
for babies who are able to sit upright
unassisted.
1.
Place NAKED upside down and unfold both support legs outward until
they snap into their locked positions.
NOTE
Always double check that the legs are securely snapped into place
before putting your child into NAKED.
2.
Turn NAKED right side up and push the flexible basin down until all sides
are fully extended.
NOTE
Make sure the drain plug within NAKED is securely fitted before
filling the tub.
3.
Place NAKED on the flat bottom of an adult tub or shower.
4.
Fill the tub with as little water as possible. Always test the water
temperature and water level before placing your baby into the tub.
Typical water temperature for bathing a baby should be between 90 and
100°F (32.2 and 37.8°C). Drain plug will turn white when the water is
above 100°F (37.8°C). While bathing your child, swivel the hook under
the tub so it is not accessible to the child.
5.
After bathing and removing your baby from the tub, drain water from the
tub by lifting the drain plug, and rotating plug to the side. Tilt the tub to
drain water.
6.
Place NAKED upside down on a flat surface and push down on flexible
basin until it is fully collapsed.
7.
To collapse leg, simultaneously press and hold the buttons on each side of
leg as you fold leg inward. Repeat on other leg.
8.
Swivel hook out and hang for drying or storage.
