11
cooled down completely.
Liquid
Before turning on the machine, make sure there is enough fog liquid in the tank. This
machine accepts most fog liquids and various densities for light or heavy fog. We
recommends to use our fog liquid or efficient/economical and creates almost odorless
fog. Approximately ¾ of its capacity. Overfilling the tank may cause the liquid to spill
during transport, because of shocks, impact and tilting of the machine. Fluid
consumption depends on the type of fluid, the amount of fog that you wish to create and
the timespan of use.
DMX control
Connect the fog machine to your DMX-controller, using standard XLR male to XLR female
cables. Select the correct DMX starting address by using the dipswitch panel just above
the XLR-connectors. A status LED is provided, indicating that the machine receives
DMX-signal from your controller.
Clogged system
It is possible that the fog output of your machine decreases over time. This may be
caused by congestion in the fluid pump system. To solve this, you have to follow the
steps described below first. Do not use special fog machine cleaning solutions first, as
these are the last expedients to save your fog machine. - If there is any fog liquid left in
your tank, remove it from the tank. - Fill the fluid tank with demineralized/distilled
water.
WARNING:
Never use tap or normal bottled water as this contains chalk. This may clog
your system, causing permanent damage.
- Fill the tank with approximately 1 liter demineralized/distilled water.
