Installation manual extruder upgrade for Bondtech_Prusa_i3 V1.1
10
● Use a knife or razor to chamfer
the inside of the tube for better
filament guidance.
Important: Do not let any left
over from the tube fall into the
HotEnd we recommend you
remove the tube before
chamfer the inside!
● Insert a push fit clip between the
HotEnd and the collet.
●
Recommended: Add a small
piece of tape, 5x20mm on the
inner ring. The low friction
between the parts may cause the
HotEnd to rotate to easily when
installed.
● Install the HotEnd into the
extruder rear, angled as shown in
the photo. And push it in place.
