Bond 52146, Owner'S Manual, Page: 10 / 42

OPERATION
Bond Manufacturing Co., Inc. | Page 10
heating item.
Wait 50 minutes after extinguishing flame prior to placing a lid (if applicable) or protective cover on
20 minutes after igniting. Flame should be a yellow/blue color and between 2 - 10 inches in height.
strike somebody’s face during the process of lighting this unit; stand away from the unit for the first
you must replace the hose (if applicable). Pumice stones/lava rocks/LavaGlass
®
could pop up and
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the
‘ OFF’
position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubblesoccur
on any connection there may be a leak.
If you smell gas or a leak is discovered turn thegas valve
off, disconnect propane gas tank and do not use the appliance until the leak isrepaired.
2.Close the cylinder valve on the propane gas tank if you don't intend to use it for a long time.
knob (M) to the 'OFF' position.
1.Turn control knob (M) clockwise to the '
LOW
' position; push and continue turning thecontrol
To Extinguish
depending on whether you want to lower or raise the flame.
6.To adjust the flame, turn the control knob (M) either clockwise or counterclockwise
instructions.
'OFF' position. Wait for 5 minutes for gas to clear and then repeat the above lighting
5.If ignition doesn't occur within a few seconds, release the control knob (M) and rotate to the
the control knob for 15 seconds.
click is heard, it may take several attemps to light the burner.
Once lit, keep holding down
4.Push the ignition control knob in fully and rotate about 1/4 turn counterclockwise until a
3.Close the door (C) on the body.
counterclockwise.
2.Open the door (C) and slowly open the valve on the propane gas tank by turning the knob
1.Make sure the control knob (M) is in the 'OFF' position.
To Light