Bond Manufacturing Co., Inc. | Page 8
To Light
To Extinguish
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the
'OFF'
position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles
occur on any connection there may be a leak.
If you smell gas or a leak is discovered turn the
gas valve off, disconnect propane gas tank and do not use the appliance until the leak is
repaired.
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion
you must replace the hose (if applicable).
Pumice stones/lava rocks/LavaGlass
®
could pop up and
20 minutes after igniting. Flame height should be a yellow/blue color between 2 - 10 inches in height.
1. Make sure the contr
ol knob (E) is in the 'OFF'
position. Slowly open the valve on the propane gas
tank by turning the knob counterclockwise.
2. Push and hold in the electronic ignit r (F) to c reate sparks within the electrode, continue to hold.
3. Push in the contr
ol knob (E) and tu
rn to the position. Keep holding down the control knob
15 seconds.
4. If ignition doesn’t occur within a few seconds, release the contr
ol knob (E) and
r
otate to the 'OFF'
position. Wait for 5 minutes for gas to clear and then repeat the above lighting instructions.
5.
1. Turn contr
ol knob (E) clockwise to the position; let the knob pop up and continue tu
rning
the contr
ol knob (E) to the
position.
2. Close the cylinder valve on the propane gas tank if you don’t intend to use it for a long time.
OPERATION
Fire product and propane gas cylinder minimum
distance must be over 60 inches (as per right side
photo)
WARNING
60”
heating item.
'LOW'
between the 'LOW' and 'HIGH' positions.
'LOW'
'OFF'
(E) to allow gas to flow for
(E)