GSC3218WA
Owner’s Manual
9
Step 7 (Install the side shelves)
a) Loosen the four side panel bolts (pre-installed) on right
side of the body assembly and al
low 1/4 b
olt’s length to
extend from the body assembly.
b) Align the large holes of the right side shelf (C) with the
bolts extended from the body assembly.
c) Push down on the right side shelf until it locks into place.
Tighten bolt connections by hand until secure.
d) Repeat the same procedure for the left side shelf (B).
e) Go back to tighten all the bolts using the screwdriver
provided.
Step 9 (Install the side burner assembly)
a) Open the side burner lid and place the side burner
assembly (S) on the right side shelf. Make certain the
venturi tube is connected properly with valve.
b) Align the holes on the side burner assembly with the
holes on the right side shelf.
c) Attached with one M4 x 12mm bolt (EE) into each
pre-drilled hole.
d) Insert one washer (HH), one spring washer (GG) and
one nut (FF) into the M4 bolt from underneath by hand.
e) Go back to tighten all the bolts using screwdriver
provided.
f) Insert the ignition cable onto the electrode.
Step 8 (Install the valve with side knob and side
knob seat)
a) Align the holes on side knob seat (T) with the holes
on the right side shelf and side burner valve. Screw
one M4 x12mm bolt (EE) into each pre-drilled hole.
b) Tighten the bolts using the screwdriver provided.
c) Insert the side burner knob (U) onto the valve shaft.
d) Tighten the bolt after insert the knob into the valve.
Insert the ignition cable
onto electrode.
