ASSEMBLY INSTRUCTIONS
STEP 1. (1)
Open the carton , make sure the
4 pieces of the carton
being open up as below
Figure STEP 1.
(2)
Lift off the carton carefully and be wary of the accessories inside
falling away. Take away the box containing lava rock.
(3)
Take all the packing materials away except for the polyfoam
rounding the top of the fire
table
.
See Figure 1.
STEP 2. (1)
Turn the fire
table
heads up on a flat ground.
(2)
Cut off the binding tape on the polyfoam and remove all the
polyfoam rounding the top of the fire
table
.
(3)
Cut off the tie fastened to the regulator at the metal stand
and set it free for installation to Propane Tank.
See Figure 2
.
STEP 3.
Attach legs (D) to the underside of the top (C) using
M6 x 15 screws (AA) and washers (BB). Tighten with
screwdriver(not included).
See Figure 3.
*If you have opened the carton and removed all packages, please disregard the STEP 1 and 2. See the STEP 3
directly.
* Please keep these owner's manual for future reference.
STEP 4.
(I) Check each part before using the product. Make sure the gas supply
system is turned "OFF"
before assembling.
See Figure A.
(II) Put the gas tank in the metal stand. Make sure the gas tank sits on the
metal stand completely.
See Figure D
. Turn the wing screw on the outer part
of metal stand clockwise to secure the gas tank tightly.
See Figure E.
(III) Locate the battery, remove the plastic cover first. Unscrew the rubber
cap of the Electric Ignitor, place a AAA battery into the battery case. Make
sure the positive pole ("+") towards the cap. Screw the cap back to the
battery case tightly.
See Figure B.
(
IV
)
Place the lava rock averagely in the fire
table
on the top of the fire
table
.
See Figure C.
DO NOT COVER THE IGNITION SCREEN when placing
the lava rock into the fire table.Always keep Ignition Screen visible.
3
4
OFF
6
Summary of Contents for 67938
Page 13: ...0 13...
