3
Pin hinge(2.5x48mm)
2.5mm
Make sure hinges are
mounted in the same line.
1mm
Rudder
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Keep some space about 1mm width between
the tailing edge and the rudder.
Drill holes to appropriate position in the rudder and epoxy
the ping hinges in them
Drill slots to appropriate position in the stabilizer .
2x12mm
Make sure hinges are
mounted in the same line.
6
Pin hinge(24x24mm)
Apply instant type CA glue to pin hinges and elevator.
Elevator
1mm
Tailing
edge
Make sure they are in
the right position while
installing.
Keep some space with 1mm width between
the tailing edge and elevator.
3mm
Glue the elevator to the stabilizer by CA and epoxy.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
3mm
34mm
103mm
103mm
28
27
30
31
29
6
32
2.5mm
Drill holes to the relevant position in the tailing edge
and epoxy the rudder to them.
Note:rubber wheels oleo struts
and retracts are optional.
Retracts strut
Nut (4mm)
1.5mm
4
TP Screw (2.6x14mm)
TP Screw (2.6x14mm)
2
Steel wire (0.5x1500mm)
2
Clevis
4
TP Screw (2.6x14mm)
6
TP Screw (2.3x12mm)
2
Plastic tube(3x50mm)
1
Nut (4 mm )
1
Wheel (75mm)
2
2
Copper joiner
Aluminum tube(3x6mm)
2
Clevis
2
2
Screw (2x10mm)
Nut (2mm )
2
2
2
Clevis
Copper joiner
Aluminum tube(3x6mm)
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Steel wire
Copper joiner
Aluminum tube
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
2
Nut (2mm )
2
Washer(2x5mm)
1
Bushing (8X6mm)
Bushing (8X6mm)
Trim a small slot to appropriate
position in the whell shaft and
fixing the shaft by set screw.
Assemble the wheel to the nose retract.
Install the nose retract .
Assemble the servo in the fuselage.
Install the servo of nose gear.
33
37
35
36
34
7
Accessory list for the coming installation steps.
