BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual

Page: 119 / 426

Section 04 ENGINE
Subsection 06 (BOTTOM END)
04-06-15
NOTE: Distance should be the same on both
sides.
Bent stopper as required to obtain the proper dis-
tance.
ASSEMBLY
Assembly is essentially the reverse of disassem-
bly procedures. However pay particular attention
to the following.
3,4, Crankshaft and Bearing
Apply Loctite 767 anti-seize on part of crankshaft
where bearing fits.
Prior to installation, place bearings into a container
filled with oil, previously heated to 75
°
C (167
°
F).
This will expand bearing and ease installation.
To properly position the outer bearing(s), a dis-
tance gauge must be temporarily installed against
the inner bearing. Slide the outer bearing until
stopped by the distance gauge, then remove it.
1. Distance gauge
TYPICAL
1. Distance gauge
2. Outer bearing
12, Distance Ring
When installing the distance ring, make sure to
position it with its chamfer toward the counter-
weight of the crankshaft.
18, Crankshaft Gear
787 Engine
Position the long flange of the gear toward the
counterweight of the crankshaft. Also, make sure
to align the gear keyway with the Woodruff key
on the crankshaft.
1. Woodruff key on the crankshaft
ENGINE DISTANCE GAUGE
717 P/N 529 034 800 (PTO)
787 P/N 529 034 900 (MAG)
947
P/N 290 876 627 (MAG)
P/N 290 876 622 (PTO)
F01B0HA
1
F01D1YA
1
2
F00D0LA
1