Section 03
ENGINE
Subsection 07
(LUBRICATION SYSTEM)
VMR2003_011_03_07A.FM
03-07-5
Installation
The installation is the opposite of the removal pro-
cedure. Pay attention to the following details.
Install O-ring
no. 6
on oil filter cover.
1. O-ring
2. Oil filter cover
3. Foreseen groove
Torque oil filter screws to 10 N•m (89 lbf•
in
).
OIL STRAINER
Removal
Remove:
– engine oil (refer to
Oil Change
)
– engine skid plate (refer to
BODY
)
– screw
no. 10
retaining oil strainer
no. 8
.
CAUTION:
Pay attention not to lose gasket ring
no. 9
on plug screw.
1. Oil strainer
2. Gasket ring
3. Plug screw
Cleaning and Inspection
Clean oil strainer with a part cleaner then use an
air gun to dry it.
On engine, clean the oil strainer area.
CAUTION:
To avoid contaminate the oil pump
and furthermore engine inside, never use an air
gun to clean the hole.
Clean both contact surfaces of plug screw.
Installation
For installation, reverse the removal procedure.
Refill engine at the proper level with the recom-
mended oil. Refer to
TECHNICAL DATA
for capac-
ity.
Start engine and let idle for a few minutes. Ensure
plug screw and magnetic drain plug areas are not
leaking.
Stop engine. Wait minimum 3 minutes to allow oil
to flow down to crankcase then check oil level. Refill
as necessary.
2
R175motr132A
3
1
WARNING
Always wear eye protector. Chemicals can
cause a rash break out in and an injury to your
eyes.
1
R175motr133A
2
3
Summary of Contents for RALLY 200 2003
Page 1: ......
