Bomar Practix 285.230 G Pulldown, Operating Instructions Manual

Page: 34 / 85

34
Manual version: 1.03/ Feb. 2010
Manual rev.: 1
Ovládá
ní str
o
je
Bedi
en
ung
der
Masch
ine
Machine control
3.3. How to use band saw
3.3.1. Cutting
Picture What to do
1. Insert the material to the vice.
2. Shift the material in claimed length of
cutting.
3. Fix the material by means of clamping
wheel. Come with vice approximately 3
mm to material.
Note: Turning the wheel in clockwise
direction the vice is tightened. Turning the
wheel in counter clockwise direction the vice
is loosened.
4. Vice and clamp the material by means of
detent lever
5. Choose desired cutting speed by
turning the switch on the motor.
6. Check the right and tight fixation of
material once again.
7 . For Practix 285.230 G manual 7 . For Practix 285.230 G pulldown
•
Turn switch no. 3 to adjust speed of saw arm
falling.
•
Security circuit must be turn ON by button on pos.
4 before cutting begin.
•
Security circuit must be switched ON after every
disconnection from electrical network
•
When material is cut, limit switch stops drive of
saw band.
•
Start the band saw by pressing button no. „3“
(START) positioned on operating lever. If button
no. „3“ is loosen, driving stops.
•
To continue in cutting please repeat points
1–7.
•
Is necessary to lead the arm to cut manually.
•
To continue in cutting, repeat p. 1–7.