16
•
Avoid the installation:
-
near heaters, next to a stove, direct sunlight or
any other heat sources;
-
at locations with high humidity (e.g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
-
near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
-
Do not expose the appliance any weather.
Electrical connection
WARNING:
•
The installation to the mains supply must conform
to the local standards and regulations.
•
Improper connection may cause to an electric
shock!
•
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
•
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
•
Make sure that the voltage supply matches the
specifications on the rating label before
connecting.
•
Connect the mains cable to a properly installed
and earthed wall outlet.
•
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
•
Ask another person to assist.
•
You possibly need: screw wrench, Phillips screw-
driver as well as a thin-blade screwdriver.
•
Remove the dummy caps, loosen the underlying
screws and remove the appliance cover.
•
Turn the appliance cover about 180°.
Disassemble the door hinge and the opposite
screws. Displace the hinge and the screws on the
respectively other side of the appliance cover.
•
Lift the appliance door from the lower hinge.
Change the position of the blind plug and dummy
cap and place the door safely aside.
•
Tilt the unit slightly backwards and block it in this
position.
•
Disassemble the lower door hinge incl. foot by
loosening the screws. Unscrew the separate foot.