21
Cleaning
Cleaning
Cleaning
Cleaning and Maintenance
and Maintenance
and Maintenance
and Maintenance
WARNING:
WARNING:
WARNING:
WARNING:
•
Always switch off and disconnect the appliance
from the power supply before cleaning and user
maintenance.
•
Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock!
Risk of electric shock!
Risk of electric shock!
Risk of electric shock! Hot steam could damage
the plastic parts.
•
The appliance must be dry before restarting oper-
ation.
CAUTION:
CAUTION:
CAUTION:
CAUTION:
•
Do not use a wire brush or other sharp, abrasive
items.
•
Do not use any acidic or abrasive detergents.
•
Do not damage the refrigerant circuit.
Cleaning the appliance including interior
Cleaning the appliance including interior
Cleaning the appliance including interior
Cleaning the appliance including interior
•
Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent.
•
Remove for that the appliance content and stor-
age at a cool location.
•
Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
•
After everything was thoroughly dried, you can
restart the operation.
Defrosting
Defrosting
Defrosting
Defrosting
The appliance has an automatic defrosting system.
During defrosting water drops drains off at the back
of the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate.
Make sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
Reverse the bulb
Reverse the bulb
Reverse the bulb
Reverse the bulb
Specification: 220
Specification: 220
Specification: 220
Specification: 220----240 V
240 V
240 V
240 V~~~~, max. 15 W
, max. 15 W
, max. 15 W
, max. 15 W
•
Loosen the screw of the lamp cover and remove
the cover to the back.
•
Replace the defective bulb.
•
Reattach the lamp cover and tighten the screw.
•
Reconnect the appliance and put into operation
again.
Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting
Before you contact an authorized specialist
Before you contact an authorized specialist
Before you contact an authorized specialist
Before you contact an authorized specialist
Problem
Problem
Problem
Problem
Cause / Action
Cause / Action
Cause / Action
Cause / Action
Appliance is
not working
or not
properly
-
Insert the power plug correctly or check
the fuse.
-
Check the temperature setting.
-
Check the ambient temperature.
-
Unblock the ventilation openings, install
the appliance freely.
Stored food
is too warm
-
Check the temperature setting.
-
Open the door only as long as neces-
sary.
-
Check the location.
Loud noise
during oper-
ation
-
Check the appliance position.
-
See the section “Operating noise”.
Water on the
appliance
bottom
-
Check the temperature setting.
-
Clean the water discharge channel /
opening.
Interior light
is not work-
ing
-
Insert the power plug correctly or check
the fuse.
-
See the section “Reverse the bulb”.
Water on the
outer sur-
face.
On days of high humidity, condensation
might occur on the outer surface of the
appliance. No malfunction!
NOTE
NOTE
NOTE
NOTE::::
If a problem still persists after following the steps
above, contact your trader or an authorized techni-
cian.
