19
•
Remove the dummy cap (B)
and insert supplied dummy
cap (A). Place the appliance door safely aside.
NOTE
NOTE
NOTE
NOTE::::
Keep the dummy cap (B) for another possible
door opening reverse.
•
Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet.
Dismount the foot bracket
and the lower door hinge.
•
Attach the door hinge at the other appliance side,
after you have unscrewed the
hinge pin and used it from the
other hinge side. Transfer and fix the foot bracket
too. Turn in the feet accordingly.
•
Replace the appliance upright. Put the appliance
door on the hinge pin and fix it in its intended po-
sition.
•
Transfer the upper door hinge at the opposite
side, after you have unscrewed the hinge pin and
used it from the other hinge side.
Put the hinge pin in the hole of
the appliance door and fasten the hinge.
•
Replace the appliance cover, which you have
removed at the beginning. Tight the screws and
clip the screw covers on.
•
Check if the door is aligned vertically and horizon-
tally optimally so that the smooth opening and
closing of the door is guaranteed.
•
Dismount the door handle and attach it to the
corresponding other door outer side. Refer to the
instructions in "Assembling the door handle".
Transfer the cover caps on the exposed holes to
the respective other door outer side.
Startup / Operation
Startup / Operation
Startup / Operation
Startup / Operation
Prior to first use
Prior to first use
Prior to first use
Prior to first use
CAUTION
CAUTION
CAUTION
CAUTION::::
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter “Cleaning and Maintenance”.
Starting the appliance
Starting the appliance
Starting the appliance
Starting the appliance
•
Connect the appliance to the power supply.
•
Operate the temperature control. See also the
following section "Settings".
Settings
Settings
Settings
Settings
Setting [0] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [1–7] regulates the different values
of the internal temperature.
Setting 0
Setting 0
Setting 0
Setting 0
Setting 1
Setting 1
Setting 1
Setting 1
Setting 7
Setting 7
Setting 7
Setting 7
Off state
Lowest setting
(warmest inside
temperature)
Highest setting
(coldest inside
temperature)
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the amount of food in the appliance.
During initial operation, turn the temperature control
to the highest setting first, until the appliance has
reached the desired operating temperature. After-
wards it is recommended to turn the control back to a
medium setting; correcting the temperature at a later
point would then be easier.
