BOMANN TSG 5701, Instruction Manual

Page: 77 / 124

77
2 Main filter: food and soil particles trapped in this
filter are pulverized by a special jet on the lower
spray arm and washed down to drain.
Cleaning the filter system
CAUTION:

The dishwasher must never be used without
the filter.

Improper replacement of the filter can reduce
performance and damage the appliance.

Do not knock out the filter for cleaning to avoid
possible deformations of the filters.
NOTE:
Check after each rinsing the filter for residues.

Turn the filter system counterclockwise and
remove it upwards.

Remove the micro filter as from the main filter.

Remove leftover food and clean the filter under
running water. Use a soft brush for the coarse
and micro filter, if necessary.

Reinstall the filter system in reverse order.
Cleaning the lower spray arm
Lime and impurities from the
rinsing water can block nozzles
and bearings of the spray arm.
Check the outlet nozzles of the
spray arm regularly for block-
ages.

Pull off the lower spray arm upwards.

Clean the arm under running water; if neces-
sary, use a soft brush for the nozzles.

Insert the spray arm again until they click into
place.
Maintenance of the dishwasher
CAUTION:
Never use spray cleaners to clean the door panel,
this may damage the door lock and electrical com-
ponents.

Clean the appliance outer surfaces and the
door sealing thoroughly with a soft, damp cloth.
Use only mild cleaning agent.

Use to remove stains inside the appliance a
dampened cloth with a little white vinegar or a
special detergent for dishwashers. If necessary,
fill detergent in and start the appliance without
dishware in the program with the highest rinse
temperature.

Recommendation: allow the appliance to run
regularly without loading in the program [Self-
Cleaning].

Dry the outer surfaces thoroughly before taking
in operation again.
Antifreeze protection
If the unit is out of operation and exposed to tem-
peratures below zero, observe the following pre-
cautions:

Disconnect the mains plug.

Close the water supply and remove the inlet
hose from the water valve.

Drain the water from the inlet hose and the
water valve.

Reconnect the inlet hose to the water valve.

Turn off the lid of the salt container and take off
the filter system. Remove the remaining water
in the sump with an absorbent sponge.