16
•
Avo
Avo
Avo
Avoid the installation:
id the installation:
id the installation:
id the installation:
-
near heaters, next to a stove, direct sunlight or
any other heat sources;
-
at locations with high humidity (e.g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
-
near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
-
Do not expose the appliance any weather.
Electrical connection
Electrical connection
Electrical connection
Electrical connection
WARNING:
WARNING:
WARNING:
WARNING:
•
The installation to the mains supply must conform
to the local standards and regulations.
•
Improper connection may cause to an electric
electric
electric
electric
shock
shock
shock
shock!
•
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
•
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
•
Make sure that the voltage supply matches the
specifications on the rating label before
connecting.
•
Connect the mains cable to a properly installed
and earthed wall outlet.
•
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door opening
Reverse the door opening
Reverse the door opening
Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
WARNING:
WARNING:
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE
NOTE
NOTE
NOTE::::
•
Ask another person to assist.
•
You possibly need:
screw wrench, Phillips screw-
driver as well as a thin-blade screwdriver.
•
Remove the plastic rivet (1) and hinge cover (2).
•
Loosen the screws (3) and remove the door hinge
(4). Lift the unit door from the door hinge (6).
•
Displace the dummy plug (5) of the appliance
door. Place the appliance door safely aside.
•
Tilt the unit slightly backwards and block it in this
position.
•
Disassemble the lower door hinge (6) incl. foot by
loosening the screws (7). Unscrew the separate
foot (8).
•
Displace and fasten the door hinge (6) incl. foot
with the screws (7) accordingly. Screw in the
separate foot (8).
•
Return the unit to the upright position. Place the
appliance door on the hinge pin and fix it in the
intended position.
•
Displace and fasten the upper door hinge (4) with
the screws (3) accordingly.
•
Put the plastic rivet (1) in the exposed hole and
replace the hinge cover (2).
•
Check that the door is aligned vertically and
horizontally to ensure proper opening and closing
of the door.
