5
05/2013
Operating noise
40 dB(A)
40 dB(A)
Maximum Loading of top shelf
21 kg
32 kg
Maximum Loading of bottom shelf
17 kg
18 kg
Unit Dimension H x W x D
84.5 x 50.5 x 53.4 cm
140.2 x 54.5 x 57.0 cm
Unit Dimension in Services H x W x D
84.5 x 88.5 x 110.0 cm
140.2 x 99.5 x 107.0 cm
Gross / net weight
32.0 / 29.0 kg
51.0 / 47.0 kg
Coolant
R600a (18g)
R600a (27g)
Light max.
10 W
10 W
1)
According ISO 23953-2 , the climate class as below
Climate Class
Temperature
℃
Relative humidity (%)
0
20
50
1
16
80
2
22
65
3
25
60
4
30
55
5
40
40
6
27
70
(2)
The actual energy consumption depends on the use and installation of the device.
The actual energy consumption depends on the usage and might therefore also be above the values determined by
the manufacturer under standard conditions. An expert knows these relations and will execute the tests with special
measurement instruments in accordance with the regulations in place.
MANUFACTURER DATA: Product is subject to changes and improvements.
I
NSTALLATION
Location
Sufficient ventilation around the device is necessary in order for the heat to dissipate properly and to
guarantee efficient cooling operation at low power consumption. For this purpose, leave sufficient
space around the device.
- Minimum clearance of 5 cm between rear side and wall,
- at least 10 cm on both sides.
IMPORTANT:
- Do not expose the device to direct sunlight.
- Do not place near heaters, next to a stove or any other heat sources.
- Do not use the device outdoors.
- Only install at a location with an ambient temperature suitable for the climate class of the device.
For information on the climate class, please refer to chapter “Specifications“ or to the rating label
located in the interior or on the rear side of the device.
- Avoid installation at locations with high humidity (e.g. outdoors, bathroom), as metal parts would be
susceptible to corrosion under such circumstances.
- Do not place the device near volatile or combustible materials (e.g. gas, fuel, alcohol, paint, etc.)
and in rooms which may have poor air circulation (e.g. garages).
Electrical connection
The kind of current (AC) and the voltage must be conform to the data of the rating label, located inside
or outside on the back of the unit. In case of heavy voltage fluctuations, it is recommended to use an
automatic alternating current regulator.
The plug, together with the grounding conductor, must fit into the wall socket. The mains plug must be
freely accessible.
Mains cable
- Do not extend or roll up the cable during operation.
- Also, the cable must not be near the compressor on the rear side, since latter one gets hot during
operation. In case of any contact, the isolation would be damaged resulting in electric leakage.
- The use of extension cables is not recommended.
- Do not connect the device to the mains with wet hands.
