19
•
To start the defrosting process turn the tempera-
ture control to the off state and disconnect the ap-
pliance from the power supply.
•
Remove the food items and keep covered at a
cool location.
•
When the ice has melted, wipe the condensate
away, empty the drip tray and dry the appliance
interior thoroughly.
•
Then you may restart the appliance by connecting
the plug and turning the temperature control.
Reverse the bulb
Reverse the bulb
Reverse the bulb
Reverse the bulb
Specification: 220
Specification: 220
Specification: 220
Specification: 220----240 V
240 V
240 V
240 V~~~~, max. 10
, max. 10
, max. 10
, max. 10 W
W
W
W
•
Remove the condensate drip tray beneath the ice
compartment.
•
Loosen the screw securing the ice compartment
with the thermostat housing and the screw secur-
ing the thermostat housing with the fridge wall.
•
Pull the thermostat housing carefully to the front.
•
Remove the light holder and change the bulb.
•
Insert the light holder in correct way; reinstall the
thermostat housing as well as the ice compart-
ment.
•
Insert the condensate drip tray back into its origi-
nal position.
•
Reconnect the appliance and put it in operation
again.
Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting
Before you contact an authorized sp
Before you contact an authorized sp
Before you contact an authorized sp
Before you contact an authorized specialist
ecialist
ecialist
ecialist
Problem
Problem
Problem
Problem
Cause / Action
Cause / Action
Cause / Action
Cause / Action
Appliance is
not working
or not
properly
-
Insert the power plug correctly or
check the fuse.
-
Check the temperature setting.
-
Check the ambient temperature.
-
Unblock the ventilation openings,
install the appliance freely.
Stored food
is too warm
-
Check the temperature setting.
-
Open the door only as long as neces-
sary.
-
Check the location.
Loud noise
during oper-
ation
-
Check the appliance position.
-
See the section “Operating noise”.
Water on the
appliance
bottom
Check the temperature setting.
Interior light
is not work-
ing
-
Insert the power plug correctly or
check the fuse.
-
See the section “Reverse the bulb”.
Water on the
outer sur-
face.
On days of high humidity, condensation
might occur on the outer surface of the
appliance. No malfunction!
NOTE:
NOTE:
NOTE:
NOTE:
If a problem still persists after following the steps
above, contact your trader or an authorized techni-
cian.
